SOYO SY-K7V DRAGON Plus! User Manual page 130

6. The Windows NT Setup screen will appear again saying "Setup will load
support for the following mass storage devices:" The list will include "Win
NT FastTrak100-Lite (tm) controller".
NOTE: If you need to specify any additional devices to be installed, do so at
this time. Once all devices are specified, continue to step 7.
7. From the Windows NT Setup screen, press the Enter key. Setup will now
load all device files and then continue the Windows NT installation.
8.
After a successful installation, the "SCSI Adapter Setup" box will show
that the "Win NT FastTrak100-Lite (tm) Controller" driver has been
installed.
* Copy the Windows NT drivers from the SOYO CD to a floppy disk.
Installing Driver with Existing Windows NT 4.0
WARNING: If you plan to move your boot drive to a mirrored RAID 1
FastTrak array, hard drives should NOT be connected to the
FastTrak100-Lite controller before performing the following
procedure. The FastTrak100-Lite drivers must be loaded on the
system hard drive (running under the existing hard drive controller)
before any hard drives are connected to the FastTrak100-Lite
controller card.
1.
Choose "Settings" from the "Start" menu.
2.
Choose "Control Panel" from the "Settings" menu.
3.
Double-click on the "SCSI Adapters" icon, which generates the "SCSI
Adapters" dialog box.
4.
Choose "Drivers," and then press "Add."
5.
In the "Install Drivers" dialog box, press "Have Disk..."
126