Checking Cmos Settings - SOYO SY-K7V DRAGON Plus! User Manual

2. Configure the jumpers of the hard drive you're preparing to connect to the
FastTrak100-Lite using the correct "Master / Slave" or "Cable-Select"
settings in the positions described in the table below.
NOTE : Sometimes the Master drive with no slave attached is called "Single."
The master slave setting differentiates two drives chained on the same
connector.
# of Drives
1
2
3
4
3. Install the hard drives into the hard drive bays of your system, including
the power cables.
4. Attach one Ultra ATA cable to each hard drive. Then attach one cable to
the IDE port on the FastTrak100-Lite. The colored edge of the cable(s)
indicates pin 1, and the blue cable connector must be attached to the
FastTrak100-Lite IDE port.
NOTE: You must use an 80-wire, 40-pin cable when connecting
an Ultra ATA/100 hard drive to the FastTrak100-Lite IDE port.

Checking CMOS Settings

For the FastTrak100-Lite to be the bootable IDE controller, confirm in the Standard
CMOS Setup that the First Boot Device is set for "SCSI".
CREATING YOUR DISK ARRAY
You will now use the FastBuild BIOS utility to create your array using the attached
drives. There are three different scenarios in creating this array. You can create an
array for performance, you can create a Security array using new hard drives
Jumper Settings
IDE Channel 1
M
M
M & S
M & S
M = Master, S = Slave
99
IDE Channel 2
----
M
M
M & S