Adjusting The Pressure Arm - Intermec PF2i User Manual

Chapter 4 — Troubleshooting and Maintaining the Printer

Adjusting the Pressure Arm

106
The printer is factory-adjusted for full-size media width. If you are
using media that is less than full width, Intermec recommends that
you adjust the position of the pressure arm so that it is centered on
the media and provides even pressure.
A poorly adjusted pressure arm may be detected by a weaker printout
on either side of the media path.
To adjust the pressure arm
1 Open the media cover.
2 Remove any ribbon.
PF2i and PF4i Mid-Range Printer User's Manual