Chapter 4 — Troubleshooting and Maintaining the Printer
Adjusting the Printer
Adjusting the Pressure Arm
120
You may need to adjust your printer to accommodate your printing
needs or improve performance. You can adjust the:
•
pressure arm.
label stop sensor (LSS) position.
•
•
printhead pressure.
•
label taken sensor.
The printer is factory-adjusted for full-size media width. If you are
using media that is less than full width, Intermec recommends that
you adjust the position of the pressure arm so that it is centered on
the media and provides even pressure.
A poorly adjusted pressure arm may be detected by a weaker printout
on either side of the media path.
To adjust the pressure arm
1 Turn off the printer.
2 Open the front door and media cover.
3 If necessary, remove the ribbon.
PX4i and PX6i High Performance Printer User's Manual