Printhead Lift Arm - Intermec pm43 Service Manual

TITLE
PM43 Service Work Instructions

Printhead Lift Arm

OPERATION:
This section covers the instructions on replacing the printhead lift arm. The purpose the of the printhead lift arm is to adjust
the printhead pressure to compensate for different media width and thickness.
Accessing the printhead lift arm for replacement will require removal of the printhead pressure adjustment mechanism and
printhead lift mechanism assembly.
Tools Required
Description
Torx Driver
Parts Required
Item Part Number
1 710-104S-001
Printhead Lift Arm Replacement
1. Remove the printhead pressure adjustment mechanism. See page 16 for instructions on how to remove the printhead
pressure adjustment mechanism.
2. Remove the printhead lift mechanism assembly. See page 21 for instructions on how to remove the printhead
lift mechanism assembly
3. Remove the spring tensioner and printhead lift actuator
4. Squeeze the push button together and carefully slide the magnetic arm assembly as shown in Figure 1. It is IMPORTANT to
watch the compression spring as you slide the arm assembly away from the
5. Reverse the instructions for re-installation.
Lift Actuator
Description
Arm,HP Sub,Assy Spare PM43
Spring Tensioner
Figure 1
Intermec Proprietary Document
Model DOCUMENT NO.
PM43,PM43C SWIPM43x-000
Part Number
T10
Compression
Spring
Arm Assembly, Magnetic, PM43
PAGE
Page
22 of 70
Qty
1
1