Intermec PF2i User Manual page 111

Fingerprint Error Messages (continued)
Message Description
Press any key If an error occurs in the Fingerprint immediate
to continue mode, for example "out of paper" when the print key
is pressed, this event is set.
Printer crash Printer crash. In most instances, when the printer
crashes, the screen is reset which causes the Intermec
Ready-to-Work indicator to turn off.
Printer turned The printer is off.
off
Printhead not Printhead not found.
found
Printhead too The printhead is overheated and needs to cool down.
hot You need to resend your print job.
Rebooted The printer has been rebooted.
RtW blink by This condition is set by the Fingerprint SYSHEALTH
application command. For more information, see the
Fingerprint Command Reference
RtW off by This condition is set by the Fingerprint SYSHEALTH
application command. For more information, see the
Fingerprint Command Reference
Setup Mode The printer is in Setup mode.
Entered
Testfeed not The printer did not perform a test feed before it
done printed out test labels. Performing a test feed
calibrates the sensor. To perform a testfeed, press the
Print button.
Transfer This is not an error condition. This message briefly
ribbon is appears after a new roll of transfer ribbon is
installed installed.
PF2i and PF4i Mid-Range Printer User's Manual
Chapter 4 — Troubleshooting and Maintaining the Printer
Intermec
Manual.
Intermec
Manual.
Ready-to-Work Error
Indicator Status Number
Off
Off
Off
Off
Off 1088
Off
Blinking
Off
Off
Blinking 1606
Blinking 1058
97