Appendix A — Specifications
140
LSS Detection Position (c)
This position is variable. For help, see
Sensor" on page
107.
Detection Slit Length (d)
The length of the detection slit (excluding corner radii) must be a
minimum of 2.5 mm (0.10 in) on either side of the LSS detection
position (c).
Detection Slit Height (e)
Measurement
Value
Maximum
21.3 mm (0.83 in)
Recommended
1.6 mm (0.06 in)
Minimum
1.2 mm (0.05 in)
Media Type
Set media type to one of these values:
•
Fingerprint: TICKET (w GAPS)
•
IPL: MARK
Note: Do not allow a perforation to break the edge of the media,
because the media may split and jam the printer.
"Adjusting the Label Stop
PF2i and PF4i Mid-Range Printer User's Manual