Intermec PF2i User Manual page 112

Chapter 4 — Troubleshooting and Maintaining the Printer
IPL Error Messages
Message Description
No Printhead Printhead not found
Open & Shut Cutter error 1. Open and shut the cutter.
Cutter
Open & Shut Cutter error 2. Open and shut the cutter.
Cutter
Open & Shut Cutter error 3. Open and shut the cutter.
Cutter
Paper Fault LSS too high. This error can occur when you run a
test feed without any media installed, or if you have
incorrect media settings. Load the printer with
media and select the appropriate media type. For
help, see
Paper Fault LSS too low. This error can occur when you run a
test feed without any media installed, or if you have
incorrect media settings. Load the printer with
media and select the appropriate media type. For
help, see
Paper Fault The printer did not perform a test feed before it
printed out test labels. Performing a test feed
calibrates the sensor. To perform a test feed, press
the Print button.
Paper Out The printer is out of paper. Load a new roll of media.
For help, see
Paused This is not an error condition. This message appears
when the print job is paused.
Press the F button to resume.
Press Feed
Printhead Hot The printhead is overheated and needs to
cool down. Wait for printing to resume
automatically.
Printhead Up The printhead is lifted. Lower the printhead.
Psu Over Power supply over temperature
Temp
Ribbon Fitted This is not an error condition. This message briefly
appears after a new roll of transfer ribbon is
installed.
98
"Loading Media" on page
"Loading Media" on page
"Loading Media" on page
Ready-to-Work
Indicator Status
Off
Blinking
Blinking
Blinking
Blinking
7.
Blinking
7.
Blinking
Blinking
7.
Blinking
Blinking
Off
Blinking
Off
Blinking
PF2i and PF4i Mid-Range Printer User's Manual
Error
Number
1058
1022
1059
1701
1005
1027