Example usage:
To configure IGMP snooping:
Static MAC Commands
The layer 2 forwarding database commands in the Command Line
Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command
enable smac
disable smac
config auto_learning
show smac
show fdb
create smac(port-based
VLAN)
create smac(802.1Q
VLAN)
delete smac
Each command is listed, in detail, in the following sections.
Figure 105. config igmp_snooping command
Parameters
[enable | disable exclude <portlist>]
port <port no.>
[mac <macaddress>
no.> | idx <mac address index list
on fdb>]
[mac <macaddress> port <port no.>
vid <vid> | idx <mac address index list
on fdb>]
[mac <macaddress> | idx <mac
address index on smac>]
102
port <port