Table of Contents
Advertisement
Each command is listed, in detail, in the following sections.
config ipif
Purpose
Syntax
Description
Parameters
Parameters
Example usage:
To configure the IP interface System:
Used to configure the System IP interface.
config ipif [ipaddress <network address> |
{gw <ipaddress>} | dhcp {vid <vlan_id>}]
This command is used to configure the System
IP interface on the Switch.
ipaddress <network address> - IP address and
netmask of the IP interface to created. You can
specify the address and mask information using
traditional format (for example,
192.168.100.100/255.255.255.0
format, 192.168.100.100/24.
dhcp - Allows the selection of the DHCP protocol
for the assignment of an IP address to Switch's
system IP address.
<vlan_id> - Specific the 802.1Q VLAN ID to the
Switch. The range between 1 to 4094.
Figure 61. config ipif command
63
of
in
CIDR
Advertisement
Table of Contents
