Snmp Commands - D-Link DES-2108 User Manual

SNMP Commands

The SNMP commands in the Command Line Interface (CLI) are
listed (along with the appropriate parameters) in the following table.
Command Parameters
create snmp
community
delete snmp
community
show snmp
create snmp host
delete snmp host
show snmp host
enable snmp traps
disable snmp traps
<community_string 20> [read_only |
read_write]
<community_string 20> [read_only |
read_write]
<ipaddress>
trap_community
<community_string>
[<ipaddress>
<community_string>]
90
{vid <vlan
| trap_community
id>}