Toshiba T2100 Series Maintenance Manual page 135

Installing the Top Cover, Display Assembly and Speaker
To install the computer's top cover, display assembly and speaker, follow the steps below and
refer to Figures 4-14 to 4-16.
1. Place the speaker into the rubber speaker holder.
2. Holding the speaker assembly in place, insert the speaker holding plate into the tab
on the right, then secure the assembly with one M2.5x4 screw.
3. Seat the top cover with display assembly into the unit, then secure the three
latches along the back of the cover.
4. Connect the speaker cable to PJ12 on the system board (Figure 4-16).
5. Connect the display cable to PJ14 on the system board (Figure 4-16).
6. Connect the display sensor switch cable to PJ11 on the system board, then
replace the glass tape over the cable (Figure 4-16).
7. Secure the two M2.5x8 silver screws on the top cover (Figure 4-15).
8. Place the battery pack frame in the chassis and secure it with four flat-head
M2.5x6 screws (Figure 4-15).
9. Close the display and turn over the computer so the back faces you.
10. Secure the three M2.5x8 silver screws on the bottom of the computer (Figure 4-
14).
11. Install the hard disk drive, keyboard, optional memory module, optional PCMCIA
card and battery pack as described in Sections 4.6 back through 4.2.
T2100 Series
4-21