Toshiba T2100 Series Maintenance Manual page 118

Tools and Equipment
The use of ElectroStatic Discharge (ESD) equipment is very important for your safety and the
safety of those around you. Proper use of these devices will increase the success rate of your
repairs and lower the cost for damaged or destroyed parts. The following equipment is
necessary to disassemble and reassemble the T2100 Series computers:
One M2 Phillips screwdriver to remove and replace screws.
Tweezers, to lift out screws that you cannot grasp with your fingers.
ESD mats for the floor and the table you are working on.
An ESD wrist strap or heel grounder.
Antistatic carpeting or flooring.
Air ionizers in highly static sensitive areas.
Screw tightening torque
When you fasten screws, be sure to follow the torque list below. Overtightening can damage
components and screws; undertightening can result in electrical shorts or other damage if
screws or components come loose.
M2 0.22 N•m (2.2 kgf•cm)
M2.5 0.36 N•m (3.5 kgf•cm)
FDD 0.22 N•m (2.2 kgf•cm)
HDD 0.3 N•m (3.1 kgf•cm) or less
4-4
T2100 Series