Table of Contents
Advertisement
Activating
the
power
saving
function
Activating
the
on-
screen
function
This function operates only with an RGB input source.
If there are no input signals from the RGB IN connector for more
than five minutes, the unit will automatically turn off and enter the
standby mode.
Press MENU to display the main menu.
Press the cursor a/¥ keys to select "POWER MENU."
Press L-CLICK to display the POWER MENU.
Press the cursor a/¥ keys to select "POWER OFF," then
press the cursor + key to select "ON" to activate the
power saving function.
To deactivate the function, set "POWER OFF" to "OFF"
by pressing the cursor ~ key.
e ùU N =
Quick-starting
the
unit
The unit can be turned on by only connecting the power cable (see
page 15) if you set "AUTO START" to "ON." There is no need to
press POWER ON on the remote control or POWER on the unit
after "AUTO START" is activated to turn on the unit.
l Press MENU to display the main menu.
Press the cursor a/v keys to select "POWER MENU."
Press L-CLICK to display the POWER MENU.
Press the cursor a/¥ keys to select "AUTO START," then
press the cursor + key to select "ON" to activate the
function.
=
To deactivate the function, set "AUTO START" to "OFF"
by pressing the cursor — key. .
A twa:
NW
29
The factory setting of this function is "ON."
When the function is activated, the source menu appears on the
screen in the following cases:
* The source menu appears for three seconds when you select the
input source with the remote control, and
f
* The source menu appears for approximately twenty seconds
when you turn on the unit.
1 Press MENU to display the main menu.
2 Press the cursor a/¥ keys to select "SETTING MENU."
3 Press L-CLICK to display the SETTING MENU.
4
Press the cursor 4/¥ keys to select "DISPLAY," then
press the cursor + key to select "ON" to activate the on-
screen function.
To deactivate the function, set "DISPLAY" to "OFF" by
pressing the cursor — key.
Advertisement
Table of Contents
