FUEL SYSTEM
Removal of the carburetor heater
- Remove the carburator warming
resistor (4).
- Remove the heater earthing connection (5).
Removal of the throttle valve
- Remove the 2 screws that secure the
chamber cap.
- Remove the chamber cap (6).
- Remove the spring.
- Remove the needle, valve and membrane
assembly.
Check that the membrane is in good
condition.
- Remove the needle stop (7).
- Remove the spring (8).
- Remove the needle (9).
The height oif the needle is factory set
and cannot be modified.
58
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
5
4
6
7
8
9