Removal Of The Thermostat; Removal Of The Temperature Sensor; Removal Of The Regulator - PEUGEOT Geopolis 250 Workshop Manual

Removal of the thermostat

- Remove the storage compartment. See:
Procedure 1. page 18.
- Disconnect the battery.
- Remove the screw that secures the wiring
harness clamp and the fuel hose anchor
bracket.
- Disconnect the lower pump from the coolant
pump to drain the cooling system.
- Remove the top (1) from the thermostat (2
screws) without disconnecting the hose.
- Remove the thermostat.
Note: After refitting, bleed the engine cir-
cuit hot and check the coolant level
in the header tank. (Peugeot appro-
ved coolant).

Removal of the temperature sensor

- Remove the storage compartment. See:
Procedure 1. page 18.
- Disconnect the battery.
- Remove the screw that secures the wiring
harness clamp and the fuel hose anchor
bracket.
- Disconnect the temperature sensor. (1)
- Remove the engine temperature sensor.
Note: After refitting, bleed the engine cir-
cuit hot and check the coolant level
in the header tank.

Removal of the regulator

- Remove the tank cover panel. See:
Procedure 3. page 19.
- Remove the RH fairing. See: Procedure 2.
page 18.
- Disconnect and remove the regulator. (1)
Reproduction ou traduction, même partielle, interdite sans autorisation écrite de Peugeot Motocycles
MISCELLANEOUS OPERATIONS
1
1
1
37