LevelOne AMG-2001 User Manual page 79

Discovery Results: The discovered new APs will be listed here. When the system's Service Zone is
set to Tag-based mode, service zones also can be assigned here. After clicking Add, the current
management page is directed to AP List, where the newly added APs will show up with a status of
"configuring". It may take a couple of minutes to see the status of the newly added AP to change
from "configuring" to "online" or "offline".
AP Type: This is the supported type of APs for centralized management.
IP Address: IP address of the specified AP.
MAC Address: MAC address of the specific AP.
AP Name: Mnemonic name of the specific AP.
Admin Password: Password required for this AP.
Template: The template which will be applied to the added AP.
Channel: The selected channel will be applied to the added AP.
Service Zone: The item is only shown when Tag-Based mode is selected. Select the name
of Service Zone such as Service Zone 1, Guest or Employee.
Add: The administrator can click Add button to register the APs to the List for management.
Input the desired name and password for the AP. Select one template, one channel, check the Add
checkbox and then click Add to add it under the managed list.
When the AP is added, it will show up in the list below and be given a new IP address set here (ex:
192.168.0.1). Check the Add box to add the AP and it will be listed to the AP list.
AMG-2001 Access and AP Management Gateway
74
User's Manual