Table of Contents
Advertisement
Selecting the Filter Rule Number 1 as an example:
Rule Number: This is the rule selected "1". Rule No. 1 has the highest priority; rule No.
o
2 has the second priority, and so on.
Rule Name: The rule name can be changed here.
o
Source/Destination – Interface/Zone: There are choices of ALL, WAN1, WAN2,
o
Default, and the named Service Zones to be applied for the traffic interface.
Source/Destination – IP Address/Domain Name: Enter the source and
o
destination IP addresses. Domain Host filtering is supported but Domain name filtering
is not.
Source/Destination – Subnet Mask: Select the source and destination subnet
o
masks.
Source- MAC Address: The MAC Address of the source IP address. This is for specific
o
MAC address filter.
Service Protocol: There are defined protocols in the service protocols list to be
o
selected.
Schedule: When schedule is selected, clients assigned with this policy are applied the
o
firewall rule only within the time checked. There are three options, Always, Recurring
and One Time. Recurring is set with the hours within a week.
Action for Matched Packets: There are two options, Block and Pass. Block is to
o
prevent packets from passing and Pass is to permit packets passing.
AMG-2001
Access and AP Management Gateway
95
User's Manual
Advertisement
Table of Contents
