After you had created the VLAN Tag and Room number mapping, you can change all of the Room
State in the same Service Zone.
Port Location Mapping Setup – Change All Room State
Default Room State: The default state of the rooms, it may be: Charge, Free or Block.
Service Zone: The service zone of these rooms
If you want to create the Room Mapping is not a contiguously VLAN Tag and Room number, then
you can create it one by one.
Port Location Mapping Setup – Create One
Room Default State: The default state of the rooms, it may be: Charge, Free or Block.
Service Zone: The service zone of these rooms
VLAN ID: The VLAN ID to be added.
Room Number: The room number mapping to this VLAN ID.
Room Description: The reference or remark information of this room.
Caution:
The VLAN Tag used in here, VLAN Port (Room) Mapping, must not be conflict with the
VLAN Tag that has been assigned to each Service Zone.
AMG-2001
Access and AP Management Gateway
221
User's Manual