Table of Contents
Advertisement
Secret: The secret key between Guest Service Device and Net Retriever for challenge
and response (MD5 Hash) to test the link. It should contain one or more lowercase letters,
uppercase letters, numbers and symbols. It also should be between 8 ~ 16 characters.
Net Retriever Server Port: The port used by Net Retriever, the default is "8324".
NR IR: The ID of the Net Retriever.
GSD IR: The ID of the Guest Service Device.
Link Test Interval: The time interval of the Link Test, the default is "300" seconds.
Now, the Net Retriever connection is finished in the Guest Service Device side. In the Net
Retriever side, it has to know the IP address of Guest Service Device, and then they can
communicate to each other.
2. VLAN Port (Room) Mapping
Configure VLAN Port Mapping, go to: System >>Port Location Mapping.
Port Location Mapping Status: Enable or Disable the Port Location Mapping, clicking
Configure to enter its setup.
After the Net Retriever connection is finished, you must setup the Room mapping. Each Room is
mapping to one VLAN Tag. And each Room can be assign to different Service Zone to get different
policy. Furthermore, you can configure the Room to different state: Charge, Free or Block.
If the state is Charge, it is the most normally usage to charge the user. If the user opens a
browser and tries to access internet, it will pop up a Login page with disclaimer, user can
select a satisfactory billing plan and begin access internet until the quota has run out.
If the state is Free, the user can access internet in this room without any charge.
If you do not want to provide any internet access right in the rooms, you may change the
state of the rooms to Block. If the user opens a browser and tries to access internet, it will
pop up a Blocking message to notice the user.
AMG-2001
Access and AP Management Gateway
219
User's Manual
Advertisement
Table of Contents
