3.4.4 WAN Bandwidth Control
The section is for administrators to configure the control over the entire system's traffic though the
WAN interface (WAN1 and WAN2 ports).
To configure WAN Bandwidth Limit
Go to: System >> WAN Traffic.
These parameters in the raw of Available Bandwidth on WAN Interface are used for matching to
the real bandwidth come from your ISP.
Uplink: It specifies the maximum uplink bandwidth that can be shared by clients of the system.
Downlink: It specifies the maximum downlink bandwidth that can be shared by clients of the
system.
AMG-2001
:
27
Access and AP Management Gateway
User's Manual