Table of Contents
Advertisement
Connecting with Wired LAN
Example of a normal network connection
Attention
f When a LAN cable is directly connected to the projector, the network connection must be made indoors.
Note
f A LAN cable is required to use the wired LAN function.
f Use shielded LAN cable (STP cable) that is compatible with category 5 or above.
f Use a LAN cable with length of 100 m or shorter.
Projector settings
1)
Use the LAN cable (Straight) to connect the projector with computer.
2)
Turn on the projector.
3)
Press the <MENU> button to display the [NETWORK/USB] menu, and then select [WIRED LAN], and
press the <ENTER> button.
4)
Set the detailed setup of [WIRED LAN].
f For details,please refer to "WIRED LAN" (x page 88).
Note
f Please confirm with your network administrator before you connect to an existing network.
f The following settings are set before the projector leaves the factory.
Computer settings
Connection can be made with wired LAN. However, confirm to your system administrator on network settings before chang-
ing any settings.
1)
Turn on the computer.
2)
Make the network setting according to your system administrator.
f If the projector settings are the default settings, the computer can be used with the following network settings.
Chapter 4 Settings - [NETWORK/USB] menu
Chapter 4 Settings - [NETWORK/USB] menu
Computer
LAN cable (straight)
[DHCP]
[IP ADDRESS]
[SUBNET MASK]
[DEFAULT GATEWAY]
[DNS1]/[DNS2]
[IP ADDRESS]
[SUBNET MASK]
[DEFAULT GATEWAY]
Projector
LAN cable (straight)
Hub
OFF
192.168.10.100
255.255.255.0
192.168.10.1
NONE
192.168.10.101
255.255.255.0
192.168.10.1
ENGLISH - 97
Advertisement
Table of Contents
