Troubleshooting
Please check following points. For details, see the corresponding pages.
Problem
f The power cord may not be connected.
f No electric supply is at the wall outlet.
Power does not turn
f The circuit breakers have tripped.
on.
f Is the lamp indicator <LAMP> or the warning indicator <WARNING> lit or blinking?
f The lamp cover has not been securely installed.
f The video signal input source may not be connected to a terminal properly.
f The input selection setting may not be correct.
No picture appears.
f The [BRIGHTNESS] adjustment setting may be at the minimum setting.
f The input source which is connected to the projector may have a problem.
f The AV MUTE function may be in use.
f The lens cap is still attached to the lens.
f The lens focus may not have been set correctly.
The picture is fuzzy.
f The projector may not be at the correct distance from the screen.
f The lens may be dirty.
f The projector may be tilted too much.
f [COLOR] or [TINT] adjustment may be incorrect.
The color is pale or
f The input source which is connected to the projector may not be adjusted correctly.
grayish.
f RGB cable is damaged.
f The input terminals may not have been correctly connected.
f The volume may have been set to the minimum level.
f The AV MUTE function may have been turned on.
No sound from the
f When the VARIABLE AUDIO OUT is plugged-in, the projector's built-in speaker is
internal speaker.
f The MUTE function may have been turned on.
f Is the audio input selection in [AUDIO SETTING] set correctly?
f The batteries may be weak.
f The batteries may not have been inserted correctly.
f The remote control signal receptor on the projector may be obstructed.
f The remote control unit may be out of the operation range.
The remote control
f Strong light such as fluorescent shine onto the signal receptor.
does not operate.
f The [REMOTE CONTROLLER] setting is set to [DISABLE] in [CONTROL DEVICE
f Is the ID number setting operation correct?
f Check if the <ON/OFF> switch on the remote control is set to "ON".
Menu screen does not
f Is the on-screen display function turned off (hidden)?
appear.
f The [CONTROL PANEL] setting is set to [DISABLE] in [CONTROL DEVICE
The control buttons of the
projector do not operate.
f There may be a problem with the VCR or other signal source.
The picture does not
display correctly.
f A signal which is not compatible with the projector is being input.
Picture from a
f The cable may be longer than the optional cable.
computer does not
f The external video output from a laptop computer may not be correct.
appear.
f Is the HDMI cable securely connected?
Picture from a HDMI
f Turn off the power of the projector and the connected devices. Then turn the power
device does not
appear or picture is
not stable.
f Isn't unsupported signal cable connected?
No sound is output
f Set the sound channel of the attached device to Linear PCM.
from a HDMI device.
EASY SETTING
f Turn off and turn on the power of the projector.
function is disabled.
Attention
f If the problem persists, after confirming the contents of the table, please consult your dealer.
130 - ENGLISH
Chapter 6 Maintenance - Troubleshooting
not available.
SETUP].
SETUP].
of the projector and the connected devices back on.
Cause
Reference
page
—
—
—
125
128
38
50
61
—
53, 76
23
46
33
20
—
61
—
—
39
49, 81
53, 76
39
54, 81
82
—
29
26
26
26
87
54
25
70
87
—
141
—
—
38, 39
—
141
—
83