Table of Contents
Advertisement
1)
Press the <ENTER> button when [NORMAL] is selected.
f The [NORMAL] screen is displayed.
2)
Press qw to select [M-DIRECT], and press the <ENTER> button.
f The [WIRELESS DETAILED SETUP] screen is displayed.
3)
Press as to select an item, and press qw to change the setting according to the instructions.
[IP ADDRESS]
[SUBNET MASK]
[SSID]
[CHANNEL]
[KEY]
4)
Press as to select [OK], and press the <ENTER> button.
r Default setting of [M-DIRECT]
f The following settings are set before the projector leaves the factory.
Note
f The authentication method is WPA2-PSK, and the encryption method is AES. Both methods are fixed.
f When you need to change initial configuration of [M-DIRECT], please contact your network administrator.
f If [KEY] is kept as the factory default value, information leak by a third party may occur. Be sure to change it from the factory
default value.
f Since the DHCP server automatically starts up, set the DHCP setting of devices to be wirelessly connected to the projector
to on and connect them.
f The [Key] may be displayed with the password of SSID depending on the devices.
Detailed setup of [USER1]/[USER2]/[USER3]
1)
Press the <ENTER> button when [NORMAL] is selected.
f The [NORMAL] screen is displayed.
2)
Press qw to select [USER1], [USER2] or [USER3], and press the <ENTER> button.
f The [WIRELESS DETAILED SETUP 1/2] screen is displayed.
3)
Press as to select an item, and press qw to change the setting according to the instructions.
[NAME CHANGE]
[DHCP]
[IP ADDRESS]
[SUBNET MASK]
[DEFAULT GATEWAY]
[DNS1]
[DNS2]
Note
f Before using the DHCP server, make sure the DHCP server is already functioning.
f For details of IP ADDRESS, SUBNET MASK, DEFAULT GATEWAY and DNS server address, ask the network administrator.
f A wired LAN and wireless LAN cannot be used in the same segment.
4)
Press s.
f The [WIRELESS DETAILED SETUP 2/2] screen is displayed.
90 - ENGLISH
Chapter 4 Settings - [NETWORK/USB] menu
Enter the IP address.
Enter the subnet mask.
Select M-DIRECT in Wireless LAN, then the SSID can be set.
Select M-DIRECT in Wireless LAN, then the Channel can be set.
1~11
Select M-DIRECT in Wireless LAN, then the KEY can be set.
Setting a key for the access point. Input either 8 to 63 alphanumerics or a 64 digit
string in the hexadecimal format.
[IP ADDRESS]
[SUBNET MASK]
[SSID]
[CHANNEL]
[KEY]
The identified names of the projectors on the application software can be changed.
ON:
If a DHCP server exists in the network to which the projector is connected, the
IP address will automatically be acquired.
OFF:
If a DHCP server does not exist in the network to which the projector is
connected, additionally set [IP ADDRESS], [SUBNET MASK ] and [DEFAULT
GATEWAY].
Enter the IP address if DHCP server is not used.
Enter the subnet mask if DHCP server is not used.
Enter the gateway address if DHCP server is not used.
Enter the DNS server address if DHCP server is not used.
Enter the alternate DNS server address if DHCP server is not used.
192.168.12.100
255.255.255.0
M-DIRECT + The last 4 digits of
the network ID
1
The same string as the SSID
Advertisement
Table of Contents
