Table of Contents
Advertisement
Horizontal (right and left)
adjustment.
Note
f Depending on the input signal, if the adjustment of [SHIFT] exceeds the effective adjustment range of the input signal, the
position of the image cannot be changed. Please adjust [SHIFT] within an effective adjustment range.
[DOT CLOCK]
(Only for computer (RGB) signals input)
Use this function to adjust and minimize the effect of interference caused by projection of patterns consisting of vertical stripes.
The projection of the striped pattern may cause cyclic patterns (noise). Adjust so that the amount of interference is at a
minimum. You can adjust the dot clock of image.
1)
Press as to select [DOT CLOCK].
2)
Press qw or the <ENTER> button.
f The [DOT CLOCK] individual adjustment screen is displayed.
3)
Press qw to adjust the value.
f The adjustment values are [-32] to [+32].
Attention
f Set it before adjusting [CLOCK PHASE].
[CLOCK PHASE]
(Only for computer (RGB) signals input)
You can adjust to achieve an optimal image when there is a flickering image or smeared outlines.
1)
Press as to select [CLOCK PHASE].
2)
Press qw or the <ENTER> button.
f The [CLOCK PHASE] individual adjustment screen is displayed.
3)
Press qw to adjust the value.
f The adjustment values are [-16] to [+16]. Adjust so that the amount of interference is at a minimum.
Note
f Certain signals may not be adjustable.
f Optimal value may not be achieved if the output from the input computer is unstable.
f To project a signal with dot clock frequency with 162 MHz or higher, noise may not disappear even if [CLOCK PHASE] is
adjusted.
f [CLOCK PHASE] cannot be adjusted when a digital signal is input.
[OVER SCAN]
Use this function when characters or pictures are cropped near the periphery of the projected image.
1)
Press as to select [OVER SCAN].
2)
Press qw or the <ENTER> button.
f The [OVER SCAN] individual adjustment screen is displayed.
3)
Press qw to adjust the level.
f The adjustment values are [0] to [+3].
Note
f It is unavailable for still image computer (RGB) signals, still image HDMI signals and [NETWORK/USB].
Chapter 4 Settings - [POSITION] menu
Press the w button.
Press the q button.
The image position moves to the
right.
The image position moves to the
left.
ENGLISH - 67
Advertisement
Table of Contents
