Table of Contents
Advertisement
Chapter 3 Basic Operations - Basic operations by using the remote control
Press the <ENTER> button again, the red frame of the sub screen will disappear and then return to switch the input source of
the main screen.
Using the P-TIMER function
You can operate the presentation timer function.
Presentations, etc. can be performed while checking the elapsed time or time remaining in the preset time.
button
1)
Press the <P-TIMER> button on the remote control.
f The count is started.
f The elapsed time or the remaining time is displayed at the bottom right of the projected image.
2)
Press the <P-TIMER> button again.
f The count is stopped.
3)
Press the <P-TIMER> button again.
f The count is resumed.
Note
f Pressing the <P-TIMER> button for at least 3 seconds to release the P-TIMER function.
f For details, please refer to the [DISPLAY OPTION] menu → [P-TIMER] (x page 74).
Using the MUTE function
This button allows you to turn off the audio output temporarily.
button
1)
Press the <MUTE> button on the remote control.
f The audio turns off.
2)
Press the <MUTE> button again.
f The audio turns on.
Setting the ID number of the remote control
When you use the system with multiple projectors, you can operate all the projectors simultaneously or each projector
individually by using single remote control, if unique ID number is assigned to each projector.
After setting the ID number of the projector, set the same ID number to the remote control.
The factory default ID number of the projector is set to [ALL]. When using a single projector, press the <ID ALL> button on
the remote control. Also, you can control a projector by pressing the <ID ALL> button on the remote control even if you do not
know the projector ID.
buttons
1)
Press the <ID SET> button on the remote control.
2)
Within five seconds, press the one-digit ID number set on the projector using the number (<1> - <6>)
buttons.
f If you press the <ID ALL> button, you can control the projectors regardless of the ID number setting of the projector.
Attention
f Since the ID number of the remote control can be set without the projector, do not press the <ID SET> button on the remote
control carelessly. If the <ID SET> button is pressed and no number (<1> - <6>) buttons are pressed within five seconds, the
ID number returns to its original value before the <ID SET> button was pressed.
f The ID number set on the remote control will be stored unless it is set again. However, it will be erased if the remote control
is left with dead batteries. Set the same ID number again when the batteries are replaced.
Note
f Set the ID number of the projector from the [PROJECTOR SETUP] menu → [PROJECTOR ID]. (x page 78)
54 - ENGLISH
Advertisement
Table of Contents
