Notes On Using Wireless Connection - Panasonic PT-VW355N Operating Instructions Manual

Notes on Using Wireless Connection

Wireless connection function of the projector uses radio waves in the 2.4 GHz or in the 2.4 GHz / 5 GHz band.
A radio station license is not required, but be sure to read and fully understand the following items before use.
r Do not use near other wireless equipment.
The following equipment may use radio waves in the same band as the projector.
When the projector is used near these devices, radio wave interference may make communication impossible, or the
communication speed may become slower.
f Microwave ovens, etc.
f Industrial, chemical and medical equipment, etc.
f In-plant radio stations for identifying moving objects such as those used in factory manufacturing lines, etc.
f Designated low-power radio stations
r If at all possible, avoid the use of cellular phones, TV sets or radios near the projector.
Cellular phones, TV sets, radios and similar devices use different radio bands from the projector, so there is no effect on
wireless communication or the transmission and reception of these devices. However, radio waves from the projector may
produce audio or video noise.
r Wireless communication radio waves cannot penetrate steel reinforcements, metal, concrete, etc.
Communication is possible through walls and floors made from materials such as wood and glass (except glass containing
wire mesh), but not through walls and floors made from steel reinforcements, metal, concrete, etc.
r Avoid using the projector in locations prone to static electricity.
If the projector is used in a location prone to static electricity, such as on a carpet, the wireless LAN or wired LAN
connection may be lost.
If the static electricity or noise make it impossible to establish a connection with the LAN, please press the power button on
the remote control or the control panel to power off the projector, and eliminate the source of static electricity or noise, then
turn on the projector.
r Using the projector outside the country
It is forbidden to take the projector outside the country or region where you purchased it, so use it only in the said country
or region. Also, note that depending on countries or regions there are restrictions on the channels and frequencies at which
you can use the wireless LAN.
r Available wireless LAN channels
The channels (frequency range) that can be used differ according to the country or region and the connecting method of the
wireless LAN. Refer to the table below.
For MIRRORING mode
(When the connecting method is [MIRRORING] (x page 123))
Country or region
For Europe and CIS
The power supplies are below
140 V
(Except for Europe and CIS)
The power supplies are above
190 V
(Except for Europe and CIS)
For M-DIRECT mode
(When the connecting method is [M-DIRECT] of [Panasonic APPLICATION] (x page 89))
Country or region
For Europe and CIS
The power supplies are below
140 V
(Except for Europe and CIS)
The power supplies are above
190 V
(Except for Europe and CIS)
Chapter 1 Preparation - Precautions for use
Standard Channels used
IEEE802.11b/g/n
IEEE802.11a/n 36 / 40 / 44 / 48
IEEE802.11b/g/n
36 / 40 / 44 / 48
IEEE802.11a/n
149 / 153 / 157 / 161 / 165
IEEE802.11b/g/n
Standard Channels used
IEEE802.11b/g/n
IEEE802.11b/g/n
36 / 40 / 44 / 48
IEEE802.11a/n
149 / 153 / 157 / 161 / 165
IEEE802.11b/g/n
Frequency band (Center frequency)
1 - 11
1 - 11
1 - 11
Frequency band (Center frequency)
1 - 13 2.412 GHz - 2.472 GHz
1 - 11 2.412 GHz - 2.462 GHz
5.180 GHz - 5.240 GHz
5.745 GHz - 5.825 GHz
1 - 13 2.412 GHz - 2.472 GHz
2.412 GHz - 2.462 GHz
5.180 GHz - 5.240 GHz
2.412 GHz - 2.462 GHz
5.180 GHz - 5.240 GHz
5.745 GHz - 5.825 GHz
2.412 GHz - 2.462 GHz
ENGLISH - 21