Removing The Internal Speaker; Installing The Internal Speaker - IBM IntelliStation M Pro 6218 Problem Determination And Service Manual

5. Reconnect the external cables and power cords; then, turn on the attached
6. Start the Configuration/Setup Utility program and reset the configuration:

Removing the internal speaker

The internal speaker is on the front panel of the computer, behind the front
adapter-retention bracket.
To remove the speaker, complete the following steps:
10. Slide the speaker out of its retaining tabs toward the top of the computer and
11. If you are instructed to return the speaker, follow all packaging instructions,

Installing the internal speaker

To install the speaker, complete the following steps:
1. Slide the speaker into the retaining tabs in the front of the computer.
2. Install the microprocessor fan assembly (see "Installing the microprocessor fan
3. Install the front adapter-retention bracket (see "Installing the front
4. Reconnect the speaker wire to the system board connector.
5. Install any full-length adapters that were removed.
6. Install the front bezel (see "Installing the bezel" on page 78).
7. Install the hard disk drive bracket, if one was removed (see "Installing the hard
8. Install the side cover (see "Installing the side cover" on page 76).
9. Reconnect the external cables and power cords; then, turn on the attached
94
IBM IntelliStation M Pro Type 6218 and 9236: Problem Determination and Service Guide
devices and the computer.
v Set the system date and time.
v Set passwords if necessary.
v Save the configuration.
1. Read the safety information that begins on page vii and "Installation guidelines"
on page 73.
2. Turn off the computer and all attached devices; then, disconnect all external
cables and power cords.
3. Remove the side cover (see "Removing the side cover" on page 75).
4. Remove the hard disk drive bracket, if one is installed (see "Removing the
hard disk drive bracket" on page 95).
5. Remove the front bezel (see "Removing the bezel" on page 77).
Note: It might be helpful to lay the computer on its left side for the remainder
of this procedure.
6. Remove any full-length adapters that are installed.
7. Disconnect the speaker wire from the system board connector.
8. Remove the front adapter-retention bracket (see "Removing the front
adapter-retention bracket" on page 79).
9. Remove the microprocessor fan assembly (see "Removing the microprocessor
fan assembly" on page 81).
lift it out of the computer.
and use any packaging materials for shipping that are supplied to you.
assembly" on page 83).
adapter-retention bracket" on page 80).
disk drive bracket" on page 97).
devices and the computer.