Oven Door Hinge; Side Panel Removal; Backguard; Storage Drawer Removal - Amana AGR5712BD Series Service Manual

Disassembly Procedures
!

Oven Door Hinge

1. Turn off power to unit.
2. Remove oven door, see "Oven Door Removal"
procedure.
3. Remove maintop assembly, see "Maintop Assembly"
procedure, steps 1 through 5.
4. Remove side panel, see "Side Panel Removal"
procedures.
5. Remove the top and bottom screws securing oven
door hinge to the front frame.
6. Remove hinge from oven chassis.
7. Reverse procedure to reinstall oven door hinge.

Side Panel Removal

1. Turn off power to unit.
2. Remove oven door, see "Oven Door Removal"
procedure.
3. Remove maintop assembly, see "Maintop Assembly"
procedure, steps 1 through 5.
4. Remove screws securing lower rear galvanized cover
from unit.
5. Remove screws securing top and back of side panel.
6. Pull rear of side panel away from range then slide
side panel forward to release from side panel
spacers.
7. Reverse procedure to reinstall side panel.
Backguard Removal
NOTE: Requires removal of oven from installation
position.
1. Remove maintop assembly, see "Maintop Assembly"
procedure, steps 1 through 6.
2. Remove screws securing upper back panel form unit.
3. Remove screws securing bottom outside edges of the
backguard to unit chassis.
4. Reverse procedure to reinstall backguard.

Storage Drawer Removal

1. Pull drawer straight out to first stop. Lift the front and
pull out to second stop.
2. Let front of door rest on floor. Place hands toward
back of drawer and lift it out.
Storage Drawer Removal
24
WARNING
To avoid risk of electrical shock, personal injury, or death:
disconnect power and gas supply before servicing.
3. To replace:
a. Place the set of rollers on the drawer behind the
set of rollers on the oven. (As shown above.)
b. Align the guides and push the drawer back into
position.

Storage Drawer Track Removal

1. Remove the storage drawer by pulling it out to the
fully open or stop position, lifting the drawer at the
rear to disengage the drawer track rollers from the
drawer runners, and sliding the drawer out of the
range.
2. The tracks are mounted to a rear support and the
frame of the range. Remove the two track mounting
screws and remove the track. If the track support is
being replaced, remove the mounting screw securing
it to the side frame and remove the support.
Oven Lamp Assembly Removal
Oven Lamp Socket/Oven Lamp and Lamp Cover
1. Remove power from unit (at the circuit breaker).
2. Open oven door and remove oven racks.
3. Hold lamp cover in place, and slide retaining wire off
cover.
NOTE: Cover will fall if not held in place when removing
retaining wire.
4. Unscrew lamp and remove.
5. Gently pry retaining clips inward towards center of
socket.
6. Once retaining clips are released, gently pull socket
into oven cavity.
7. Label and disconnect wire terminal connections and
remove socket.
8. Reverse procedures to reassemble.
NOTE: Reposition fiberglass insulation around oven
light socket to eliminate possibility of heat
related problems.
Lamp
Cover
Lamp, Socket and Cover Removal
16026785
Retaining Clip
Lamp
Retaining Clip
(40 watts)
© 2005 Maytag Services
Lamp
Socket