Table of Contents
Advertisement
Testing Procedures
To avoid risk of electrical shock, personal injury or death; disconnect power and gas to range before servicing,
unless testing requires power and/or gas.
M1 CONTROL TESTING NOTES:
1
"Action Taken" applies as long as the condition exists. If the condition goes away, the control recovers.
2
Flash rate: 0.2 seconds on, 0.1 second off. Pressing any key will clear the display until the fault clears and is re-triggered.
3
"Action Taken" applies until there is a POR (Power On Reset ["hard reset"]).
4
If the control believes the door is locked, it will attempt to unlock it when the function cancels and the cavity temperature cools.
5
Special conditions for latch faults (9dxx):
•
A known good unlock position is defined as when the unlock switch reads closed and lock switch reads open.
•
A known good lock position is defined as when the unlock switch reads open and lock switch reads closed.
A faulted switch means the switch input is reading an invalid state, neither open nor closed.
•
•
If at POR, the latch is not at a known good unlock position.
•
Affected DLBs (Double Line Breaks) and loads are disabled during detection.
•
If the control is in a known good unlock position and the lock switch becomes faulted:
•
The control will not fault.
If a function requiring latch movement is attempted while the lock switch is faulted, the control will sound an error
•
tone and the function will be disabled.
•
If the control is in a known good lock position and the unlock switch becomes faulted:
•
The control will not fault.
•
If a function requiring latch movement is attempted while the lock switch is faulted, the control will sound an error
tone and the function will be disabled.
NSC Control Testing Procedures
Control
NSC
Oven temperature
adjustment
NSC
Keypad Lockout
NSC
Temperature display
NSC
Sabbath Mode
© 2005 Maytag Services
!
Feature
Press Bake pad.
Enter 550 on the digit-pad.
Immediately press and hold Bake pad for
3 to 5 seconds.
Oven can be adjusted from -35 to +35
degrees in 5
More + or Less - pads. To avoid over
adjusting the oven, move temperature 5
each time. Wait 4 seconds for the data
entry timer to expire to accept the change.
Temperature adjustment will be retained
even through a power failure.
Press and hold Cancel and Timer pads
for 3 to 5 seconds. Press More + or
Less - pads to change.
Press and hold Cancel and Bake pads
for 3 to 5 seconds. Press More + or
Less - pads to change.
Hold Clock pad for 3 to 5 seconds to
activate Sabbath mode.
Hold Clock pad for 3 to 5 seconds to
disable Sabbath mode.
Desired bake function must be initiated
before entering Sabbath mode.
WARNING
Test Procedure
°
increments by pressing
°
16026785
Results
While increasing or decreasing oven
temperature, this does not affect self-
cleaning temperature.
This mode disables keypad input to
deter against accidental keypad entries.
This mode enables the user to indicate
°F or °C on the display.
"SAb" flashes for 5 seconds, then
remains on until timed-out or cancelled.
The status "SAb" is NOT fault code
5A6.
All pad inputs are disabled except for
CANCEL and CLOCK pads.
This mode disables the normal 12 hour
shutoff to allow operation of the bake
mode for a maximum of 72 hours.
The oven light is not disabled.
19
Advertisement
Table of Contents
