Table of Contents
Advertisement
Disassembly Procedures
Oven Tank Removal
1. Turn off power to range.
2. Remove oven door and racks.
3. Remove bake element, broil element and smoke
eliminator. Remove capillary hole cover and capillary
clip, or, remove heat sensing element. Remove chip
cover and tank securing screws.
4. Remove rear cover, disconnect wiring, remove oven
bracket screws (2), and withdraw capillary tube.
5. Release oven tank brackets at rear. Maneuver tank
from frame.
6. Transfer oven light assembly to replacement tank.
7. Reverse procedure to assemble.
Oven Door Removal
1. Remove screws securing door to hinge assembly
(new compression hinges only).
2. Open door to first stop position (1/3 open) then grasp
both sides and lift up off the hinges.
Frameless Door Disassembly
1. Open oven door and remove screws securing door to
hinges (if so equpped).
2. Open oven door to first stop position(1/3 open) then
grasp both sides and lift off the hinges. Place on a
protected surface.
3. Remove screws on right and left sides of oven door.
4. Remove screws from the bottom of oven door. Detach
right and left end caps and glass support angles.
5. Remove side screws securing top door trim to oven
backer. Seperate glass outer door, trim and handle
from door assembly.
6. Detach door handle by removing door handle screws.
7. Detach heat shield from oven door backer, by
removing hex screws.
8. Access remainder of door assembly by removinghex
screws from oven door backer.
9. Reverse procedure to reassemble.
RS2320001 Rev. 2
TO AVOID THE RISK OF ELECTRICAL SHOCK, PERSONAL INJURY, OR DEATH,
DISCONNECT POWER TO THE OVEN BEFORE SERVICING.
Oven Door Hinge
1. Turn off power to oven.
2. Remove oven door assembly from the range, remove
screws securing oven door to hinges if so equipped.
3. Carefully open the hinge fully, and insert a wooden
dowel or screwdriver bit into opening marked A on the
following diagram.
4. Remove the top and bottom screws securing hinge
assembly to the front frame.
5. Slide the hinge assembly up and move top of hinge
towards rear of the range. Withdraw hinge assembly
through the frame opening.
6. Reverse procedure to reinstall oven door hinge
assembly.
32
Advertisement
Table of Contents
