Table of Contents
Advertisement
Conversion Instructions, Self-Clean Models
2ULILFH &RQYHUVLRQ
To convert this unit to LP gas from Natural gas will require
the exchange of orifice hoods.
fjmloq^kq: Save all natural orifice hoods that are
removed.
l“‚‹ _’‹‚ `Œ‹“‚†Œ‹
Remove all oven racks.
NK _~ˆ‚ _’‹‚
a. Remove oven bottom (figure 2).
b. Remove screw from the bake burner (figure 3).
c. Remove the bake burner from the orifice fitting.
`^rqflkW The igniter is fragile. Take care not to
damage it.
d. Gently lay the bake burner in the bottom of the
range.
e. Remove warming drawer or storage drawer.
f. Remove access cover to orifice (figure 4).
g. Remove the bake orifice hood with a ò² (12.7 mm)
socket wrench counter-clockwise.
h. Place the black-colored orifice stamped 1.3 on the
fitting turning it clockwise by hand approximately one
turn. Tighten the orifice hood with a ò² PP
socket wrench clockwise approximately 2ò turns.
i. Replace the bake burner.
j. Replace the oven bottom.
k. Replace access cover and drawer.
SCREW
© 2005 Maytag Services
CLIP
cfdrob O
cfdrob P
OK _Œ†‰ _’‹‚ `Œ‹“‚†Œ‹
a. Remove the screw from the broil burner.
b. Gently lay the broil burner on the oven bottom.
`^rqflkW The igniter is fragile. Take care not to
damage it.
c. Remove the broil orifice hood with a ò² (12.7 mm)
socket wrench.
d. Place the green-colored orifice hood stamped 57 on
the fitting turning the orifice clockwise by hand
approximately one turn. Tighten the broil orifice hood
with a ò² PP socket wrench clockwise
approximately 2ò turns.
e. Replace broil burner.
f. Replace oven racks.
p’ƒ~€‚ _’‹‚ `Œ‹“‚†Œ‹
1. Remove all grates.
2. Mark ignitor location on the main top with a pencil. This
mark on the main top is used as a reference point
when replacing the burner assembly to ensure that the
burner is tightened to its original position.
3. Place burner wrench (part no. 8312D075-60, available
from the dealer or authorized service agency) over the
surface burner assembly with the ignitor positioned
inside the gap in the wrench ring (figure 5). This
prevents the ignitor from being damaged when the
wrench grips the burner assembly. Rotate the burner
assembly approximately one-eighth turn
counter-clockwise and lift from the main top.
2
16026785
SCREW
cfdrob Q
cfdrob R
C–3
Advertisement
Table of Contents
