Table of Contents
Advertisement
Disassembly Procedures
!
Storage Drawer
1. Remove storage drawer by pulling it out to fully open
or stop position, lifting the drawer at the rear to
disengage the drawer track rollers from the drawer
runners, and then sliding the drawer out of the range.
2. To remove outer drawer panel assembly, remove
panel mounting screws (2 top, 2 bottom) and remove
assembly from drawer liner. If outer drawer panel,
glass, or glass frame trim is being replaced, drill out
mounting rivets, separate glass and frame from
drawer panel, and replace item as required. Use
replacement rivet, part number 0096342, to
reassemble drawer panel assembly.
3. If storage drawer liner is being replaced, remove
outer drawer panel assembly (Step 2) and drill out
drawer liner mounting rivets. Use replacement rivet,
part number 0096342, reassemble liner.
4. If storage drawer assembly is being replaced, remove
outer drawer panel assembly (Step 2) and drawer
liner (Step 3). Drill out left and right drawer runner
mounting rivets. Use replacement rivet, part number
0076357, to mount storage drawer runners.
5. If left or right storage drawer runner is being replaced,
remove drawer from range (Step 1) and drill out the
appropriate runner mounting rivets. Use replacement
rivet, part number 0076357, to mount replacement
runner.
Storage Drawer Track
1.
Remove storage drawer by pulling it out to fully open
or stop position, lifting drawer at rear to disengage
drawer track rollers from drawer runners, and sliding
drawer out of the range.
2. Tracks are mounted to a rear support and frame of
range. Remove track mounting screws and remove
track. If track support is being replaced, remove
mounting screw securing it to side frame and remove
support.
Oven Door Hinge
1. Turn off power to the range.
2. Remove oven door.
3. Carefully open the hinge to fully open position and
insert a spacer approximately 1/2" in diameter into
hinge slot which will retain hinge arm in extended
position as shown in the following diagram.
NOTE: Be careful not to allow spacer to slip out as
damage to front frame or injury to installer may
occur.
4. Remove hinge mounting screws from front frame.
5. Slide hinge upward and then move top of hinge
toward rear of the range and withdraw hinge through
frame opening.
WARNING
Unplug power source and shut off gas suppl before servicing,
unless testing requires it.
NOTE: An alternate method would be to remove right
or left end panel and withdrawing hinge. This
method does not require hinge arm to be in the
fully extended position only open hinge arm to
first "BROIL" stop position.
6. Reverse procedure to reinstall hinge. Carefully
support hinge body with our foot then open hinge
arm and install pin support.
Left Side View (Open)
Surface Burner Module
1. Remove surface burner module by lifting module top
tab and sliding module towards front of the range.
2. To remove module top, depress top retaining clips on
either side of the module pan and lift top off of the
pan. If module top is being replaced, drill out top
retaining clip mounting rivets and remount clips on
replacement top (use 0041915 mounting rivet)
3. To remove front or rear burners, remove burner
retaining screw, lift burner slightly to disengage
burner retaining tabs from ignitor and burner
mounting bracket, and slide burner out of venturi
support.
4. Electrode connector, electrode cap and bracket,
venturi support, and burner base assembly can be
removed by removing screws securing assembly to
module pan supports. The electrode, cap, and
bracket can now be replaced by removing mounting
screws and unplugging electrode wire lead from
electrode connector. Electrode connector can also
be replaced by removing connector mounting screw.
5. Module pan ground pin can be replaced by removing
pin mounting screw and lock washer after removing
module top.
53
RS2310003 Rev. 0
Advertisement
Table of Contents
