M1 Control Testing Procedures - Amana AGR5712BD Series Service Manual

Testing Procedures
To avoid risk of electrical shock, personal injury or death; disconnect power and gas to range before servicing,
unless testing requires power and/or gas.

M1 Control Testing Procedures

Control
M1 Oven temperature
adjustment
M1 Temperature display
M1 Clock display
M1 24-hour clock
M1 Factory default
M1 Twelve hour off
M1 Sabbath mode
M1 Child lockout
M1 Diagnostic code
display
16
!
WARNING
Feature
Press BAKE pad.
Enter 550 on the digit pad.
Immediately press and hold BAKE
pad for 3 to 5 seconds.
Oven can be adjusted from -35 to +35
degrees in 5-degree increments by
pressing MORE+ or LESS- pads. To
avoid over adjusting the oven, move
temperature 5 degrees each time.
Wait 4 seconds for the data entry
timer to expire to accept the change.
Temperature adjustment will be
retained even through a power failure.
Press and hold CANCEL and BAKE
pads for 3 to 5 seconds. Press
MORE+ or LESS- pads to change.
Press and hold CANCEL and CLOCK
pads for 3 to 5 seconds.
Press and hold CANCEL and DELAY
pads for 3 to 5 seconds. Press
MORE+ or LESS- pads to change.
Press and hold CANCEL and KEEP
WARM pads for 3 to 5 seconds.
Control automatically cancels cooking
operation and removes all relay drives
12 hours after the last pad touch.
Hold CLOCK pad for 3 to 5 seconds to
activate Sabbath mode.
Hold CLOCK pad for 3 to 5 seconds to
disable Sabbath mode.
Desired bake function must be initiated
before entering Sabbath mode.
Press and hold CANCEL and COOK
& HOLD pads for 3 to 5 seconds until
beep sounds.
To reactivate the control, press and
hold CANCEL and COOK & HOLD
pads for 3 to 5 seconds.
Press and hold MORE+ pad within 30
seconds of powering up the unit.
Cycle through the codes using the
MORE+ or LESS- pads.
16026785
Test Procedure Results
Increasing or decreasing oven
temperature does not affect self-cleaning
temperature.
This mode enables the user to indicate
°F or °C on the display.
Allows clock to be toggled On or OFF.
Allows the time on the clock to be
toggled from 12-hour or 24-hour display.
Allows the clock to be reset to factory
settings.
See Sabbath mode to disable.
"SAb" flashes for 5 seconds, then
remains on until timed-out or cancelled.
The status SAb is not fault code 5Ab.
All pad inputs are disabled except for
CANCEL and CLOCK pads.
This mode disables the normal 12 hour
shutoff to allow operation of the bake
mode for a maximum of 72 hours.
The oven light is not disabled.
This safety feature prevents children
from accidentally programming the oven.
The electronic oven control is disabled.
Child lockout features must be reset after
a power failure.
The last 5 diagnostic codes are stored in
the non-volatile memory.
See
Description of Error Codes
"
explanation.
© 2005 Maytag Services
for
"