Cutting Off The Media - Roland VersaUV LEC-300A User Manual

2-3 Loading and Cutting Off Media

Cutting Off the Media

Some media may be thick or may be composed of plastic or other hard material.
For such media, never perform cutoff using
function or other problems.
Procedure

Close the front cover.
Make sure
 Hold down
The media is cut off.
The cutoff location on the media is as shown in the figure below.
You can make the setting in the software RIP for automatic media cutoff after printing or cut-
ting has finished. For information on how to make the setting, refer to the documentation for
the software RIP you're using.
Important Notes on Using the Long Media Clamps
When you're using the long media clamps, be sure to set the [MEDIA CLAMP] menu
item to [LONG] to disable media cutoff. Performing cutting the media when the long
media clamps are installed causes interference with the separating knife, which may
result in malfunction or damage to the machine.
If you want to separate the media after printing has finished, be sure to first detach the
long media clamps, then set the [MEDIA CLAMP] menu item to a setting other than
[LONG].
 P. 96, "Printing Media That Warps Easily"
40
Chapter 2 Basic Operation
lights up.
for one second or longer.
Blade
protector
Printed
portion
. Doing so may cause mal-
The media is fed
to the front.
The media is
cut off here.
Blade
protector