Aligning Automatically And Cutting - Roland VersaUV LEC-300A User Manual

Aligning Automatically and Cutting

When you make the setting for reading crop marks when sending cutting data from the computer,
alignment is performed with the presence or absence of crop marks determined automatically. For
information on how to make the setting, refer to the documentation for the software RIP you're using.
Procedure

Crop marks

Send the cutting data.
Alignment is performed automatically, then cutting starts.
If Automatic Alignment Cannot Be Performed
CROPMARK ERROR
NOT FOUND

Reload the media, then send the data again.
 If this does not resolve the problem, then perform alignment manually.
 P. 123, "Aligning Automatically and Cutting"
If the crop marks cannot be detected easily because of the effects of media warping or the like, then
perform alignment manually. When you want to perform automatic alignment with lengthy media, we
recommend performing output with the data separated into sizes that are as short as possible. With
large sizes, error due to warping and the like increases, making smooth detection impossible.
5-7 Performing Printing and Cutting Separately
Blade protection
5 degrees or more
5 degrees or more
If the machine fails to detect the crop marks, the screen shown in the
figure appears and operation stops. If this happens, press
take action as follows.
Load the media.
Angled no more than 5 degrees.
Otherwise alignment becomes impossible.
Chapter 5 Feature Reference
, then
123