Performing Cutting; To Perform Cutting - Roland VersaUV LEC-300A User Manual

2-6 Performing Cutting

To Perform Cutting

To perform cutting, carry out the procedure described below.
Move the media clamps to locations where they don't clamp the media. Alter-

natively, remove the media clamps.
When You're Performing Cutting Only
When you're performing cutting, then if you're cutting roll media, allow the

media to hang down from the rear of the machine.
If cutting is started without doing this first, a motor error may occur or the roll may fall because
the media is pulled with excessive force.
Media clamps
Turn the media flanges by hand
to pull out the necessary length
from the roll.
Chapter 2 Basic Operation
49