If A Message Appears - Roland VersaUV LEC-300A User Manual

6-7 If a Message Appears

These are the main messages that appear on
the machine's display to prompt correct op-
eration. They do not indicate any error. Follow
the prompts and take action accordingly.
[1 n 2 n 3 n 4 n ...]
Only a small amount of ink remains. Replace the
cartridge indicated by the flashing number with a
new cartridge.
[PRESS POWER KEY TO CLEAN]
This appears when the machine has been unused for
about one month.
This feature is to remind you to switch on the sub
power once a month.
P. 85, "4-6 When Not in Use for a Prolonged Period"

[SET CARTRIDGE.]
Insert the ink cartridge indicated by the flashing
number. This message appears at times such as dur-
ing ink cartridge replacement.
[REMOVE CARTRIDGE.]
Remove the ink cartridge indicated by the flashing
number. This message appears at times such as dur-
ing ink cartridge replacement.
[SET CL-LIQUID]
Insert the SOL INK cleaning cartridge indicated by
the flashing number. This message appears at times
such as during head cleaning.
[REMOVE CL-LIQUID]
Remove the SOL INK cleaning cartridge indicated by
the flashing number. This message appears at times
such as during head cleaning.
[END OF THE SHEET]
The trailing edge of the media was detected during
operation. Press any button on the operation panel
to clear the message. Load new media.
[SHEET NOT LOADED PRESS SETUP
KEY]
Load media and press
pears when an attempt to perform a printing test
was made while no media was loaded.
162
Chapter 6 What to Do If
[INSTALL DRAIN BOTTLE]
Check whether the drain bottle is installed. Install the
drain bottle, then press
[CHECK DRAIN BOTTLE]
This appears when a certain amount of discharged
fluid collects in the drain bottle. To clear the mes-
sage, press
[DRAIN BOTTLE] menu and discard the discharged
fluid in the bottle.

[CLOSE THE COVER (FRONT COVER, SIDE
COVER or MAINTENANCE COVER]
Close the front cover, side cover, maintenance cover.
For safety, the carriage does not operate while a
cover is open.
[SET HEAD HEIGHT TO xxx]
The height of the print heads is lower than the height
specified on the computer. The heads move to a loca-
tion where you can operate the height-adjustment
lever. Adjust to the displayed height, then press
[TIME FOR MAINTENANCE]
It is time to clean the heads using the cleaning kit.
After verifying, press

[TIME FOR WIPER REPLACE]
It is time to replace the wipers. After verifying, press

[CIRCULATING INK]
The white ink is being circulated inside the machine.
This is automatically carried out to prevent settling
of the white ink. Wait until the displayed message
changes.
. This message ap-
. If this screen appears, go to the
P. 62, "Disposing of Discharged Ink"
.
P. 68, "4-3 Cleaning Using the Cleaning Kit"
.
P. 77, "Replacing the Wipers"
.
.