Table of Contents
Advertisement
Tx Delay
Tx Reinit
Port Configuration
Port
Mode
Optional TLV
Port Descr
Sys Name
Sys Descr
Sys Capa
Mgmt Addr
Save
Reset
multiplied by Tx Interval seconds.
Valid values: 2 – 10 times
If some configuration is changed (e.g. the IP address) a new LLDP frame is
transmitted, but the time between the LLDP frames will always be at least the value
of Tx Delay seconds. Tx Delay cannot be larger than 1/4 of the Tx Interval value.
Valid values: 1 – 8192 seconds
When a port is disabled, LLDP is disabled or the switch is rebooted a LLDP
shutdown frame is transmitted to the neighboring units, signaling that the LLDP
information isn't valid anymore. Tx Reinit controls the amount of seconds between
the shutdown frame and a new LLDP initialization.
Valid values: 1 – 10 seconds
The switch port number of the logical LLDP port.
Select LLDP mode.
Rx only: The switch will not send out LLDP information, but LLDP information
from neighbor units is analyzed.
Tx only: The switch will drop LLDP information received from neighbors, but will
send out LLDP information.
Disabled: The switch will not send out LLDP information, and will drop LLDP
information received from neighbors.
Enabled: The switch will send out LLDP information, and will analyze LLDP
information received from neighbors.
When checked the "port description" is included in LLDP information transmitted.
When checked the "system name" is included in LLDP information transmitted.
When checked the "system description" is included in LLDP information transmitted.
When checked the "system capability" is included in LLDP information transmitted.
When checked the "management address" is included in LLDP information
transmitted.
Click to save the changes.
Click to undo any changes made locally and revert to previously saved values.
-54-
Advertisement
Table of Contents
