Planet Networking & Communication Hot Spot WSG-403 User Manual page 40

Subnet Mask
Gateway IP Gateway
Primary DNS Server
Secondary DNS Server
PPPoE
Item
User Name
Password
PPP MTU Setting
TCP MSS Setting
Item
Service Name
Connect on Demand and Max Idle Time
Connect on Demand Enable
Max Idle Time
38
Enter the subnet mask for the IP address.
Enter the Gateway IP address for the xDSL/Cable connection (provided by
your ISP).
A primary DNS server IP address for the xDSL/Cable connection (provided
by your ISP).
A secondary DNS server IP address for the xDSL/Cable connection
(provided by your ISP). If the primary DNS Server IP were not available,
meanwhile, Secondary DNS Server IP would start in the same time.
Figure 3-40 PPPoE Setting Screen
Default
Empty Enter your PPPoE account name. The user name can consist
of up to 80 alphanumeric characters and is case sensitive.
Empty Enter your PPPoE password. The password can consist of up
to 80 alphanumeric characters and is case sensitive.
1492 MTU (Maximum
transmission unit size.
1452 MSS (Maximum Segment Size) specifies maximum segment
size.
Default
Empty Enter the service name provided by your ISP. The service
name can consist of up to 64 alphanumeric characters and is
case sensitive.
You can configure your WSG-403 to cut your connection with
your ISP after a specified period of time (Max Idle Time). If
10 Minutes
you have been disconnected due to inactivity, Connect on
Demand enables your WSG-403 to automatically re-establish
your connection as soon as you attempt to access the
Internet again. If you wish to activate Connect on Demand,
Description
Transfer Unit) specifies maximum
Description
WSG-403 User Guide