Your Pc Requirements; Getting Start - Planet Networking & Communication Hot Spot WSG-403 User Manual

Your password from your ISP
PPTP
PPTP Server IP Address from your ISP
PPTP Local IP address from your ISP.
PPTP Local IP subnet mask from your ISP.
Your user name from your ISP
Your password from your ISP

2.3.3 Your PC Requirements

The Static IP settings for the PC
Your PC's fixed IP address
Your PC's subnet mask
Your PC's default gateway IP address
Your PC's primary DNS IP address
Note:
1. The gateway's default IP address setting is "192.168.0.1".
2. The gateway's default subnet mask setting is "255.255.255.0".
The Dynamic IP settings for the PC
We recommend that you leave your IP settings as automatically assigned. By default, the WSG-403 is a DHCP server, and it will give
your PC the necessary IP settings.
Note:
Before turn on the WSG-403, make sure there is no other DHCP server in the LAN network, otherwise it will influence the whole
network operation.

2.4 Getting Start

1. Place the WSG-403 and WSG-ACG3 Printer on a flat work surface.
2. Connect the Ethernet cable to the WSG-403's LAN port.
3. [optional] Connect the other end of the Ethernet cable to the WSG-ACG3Account Generator Printer's RJ45 port.
4. Ensure that your modem and computer are both switched on.
5. Use the supplied cable to connect
6. Connect your computer to one of the 10/100 LAN ports on
7. Configure the further parameters via a Web browser.
14
the WSG-403's WAN port to the modem. Check that the Cable/xDSL Status LED lights.
the WSG-403. Check that the LAN Port Status LED lights.
WSG-403 User Guide