Rear Panel; Technical Specifications; Hardware Specifications - Planet Networking & Communication Hot Spot WSG-403 User Manual

Wireless subscriber gateway
Table of Contents

Advertisement

Note:
1.
Use only the bundled AC-DC adapter for the power system, other power adapter could damage the device permantly.
2.
During the firmware upgrade process, please do not power off the device, otherwise it could damage the device perman

1.4.2 Rear Panel

The rear panel of the WSG-403 is shown below.
1. RS-232: Reserve for manufacture use.
2. LAN (1-4):
The rear panel support
s four auto-sensing RJ-45 ports and all ports can be auto-switched to MDI-II connections. The LAN ports used for
linking hosts or other network devices. The individual port can be either connected to 100Base-TX networks or 10Base-T networks.
When connecting to a 100Base-TX network, the ports operate at 100Mbps in half-duplex mode or 200Mbps in full-duplex mode. When
connecting to a 10Base-T network, the ports operate at 10Mbps in half-duplex mode or 20Mbps in full-duplex mode.
3. W
AN: One Ethernet port used for linking xDSL or Cable Modem. 10/100Base-TX auto-negotiation and auto MDI also supported.
WAN port also complied with IEEE802.3af Power over Ethernet that can direct connect to IEEE802.3af complied injector (Mid-span) or
PSE (End-span) for WSG-403's power system.
Note:
1.
Either 5C DC power or IEEE802.3af PoE is allowed for the device. Use of both power systems could damage the device permantly.
2.
Please consult your local dealer about the IEEE802.3af Power over Ethernet equipments. Use of non 802.3af complied Power over
Ethernet equipments could damage the device permantly.
4. Reset
Button:
The WSG-403 h
as a reset button at the rear panel of the device. Use this function to reset the system back to factory defaults. One
push and release will reboot the system. Hold the button for 5 seconds and release will factory reset the WSG-403.
5. Po
wer Jack: Used to connect the external power supply with the WSG-403.

1.5 Technical Specifications

1.5.1 Hardware Specifications

Network Specification
IEE802.3 10Base-T Ethernet
8
Figure 1-4 WSG-403 Rear Panel
tly.
This
WSG-403 User Guide

Advertisement

Table of Contents
loading

Table of Contents