Appendix A Signal Connection Arrangements - Planet Networking & Communication Hot Spot WSG-403 User Manual

Appendix A Signal Connection Arrangements

RJ-45 Ethernet Port
The WSG-403 RJ-45 Ethernet port can connect to any networking devices that use a standard LAN interface, such as a Hub/Switch Hub
or Router. Use unshielded twisted-pair (UTP) or shield twisted-pair (STP) cable to connect the networking device to the RJ-45 Ethernet
port.
Depending on the type of connection, 10Mbps or 100Mbps, use the following Ethernet cable, as prescribed.
10Mbps: Use EIA/TIA-568-100-Category 3, 4 or 5 cable.
100Mbps: Use EIA/TIA-568-100-Category 5 cable.
Figure A-1 RJ-45 Connector and Cable Pins
Note: To prevent loss of signal, make sure that the length of any twisted-pair connection does not exceed 100 meters.
Wireless Subscriber Gateway
121