Removing A Compact Flash Card - Symbol PDT 8100 Series Product Reference Manual

PDT 8100 Series Product Reference Guide for Pocket PC 2002
2. Remove the flash card cover at the top of the battery compartment by pulling the
top out, and lifting the cover up.
Compact Flash
Card Cover
Figure 1-13. Removing the Compact Flash Card Cover
3. Insert the flash card into the compartment with the pins facing forward, and the
main label facing down. It only fits one way. The two metal tabs on the locking
mechanism will prevent you from pushing the card all of the way in.
4. To fit the card into place, push down and in at the same time, so that the lip of the
compact flash card slips under the tabs of the locking mechanism.
5. Replace the flash card cover by inserting the bottom first, and pressing the top in.
Note: After you insert or remove a compact flash card, you must replace
the flash card cover or the terminal will not function.
6. Reinsert the battery and battery cover.
7. Perform a soft reset (see Performing a Warm Boot on page 2-31).

Removing a Compact Flash Card

To remove the compact flash card:
1. Open the battery cover and remove the battery and flash card cover.
1-16
Figure 1-14. Inserting a Compact Flash Card