The terminal's battery is fully charged after approximately 2 1/2 hours.
Note: If the battery in the terminal is low, the Terminal Status LED may
flicker or turn yellow during an ActiveSync operation. The LED
returns to red when the operation is complete.
Charging Spare Batteries
To charge a spare battery, insert the battery in the spare battery charging slot in the back
of the cradle, so the contacts are facing down and towards the back of the cradle. Press the
battery down into the slot until firmly seated.
The Spare Battery Status LED turns red to indicate charging, then green when the battery
is fully charged. The battery is fully charged after approximately 2 1/2 hours.
Spare Battery
Status LED
Figure 1-9. Charging the Spare Battery
Getting Started
1-11