Prepare The Printer To Print Rewritable Cards - DataCard SD160 User Manual

Prepare the Printer to Print Rewritable Cards

1.
Open the printer cover and remove the print ribbon cartridge.
2.
Remove the print ribbon from the cartridge and set it aside.
3.
Make sure that the cleaning roller with the replaceable cleaning sleeve is installed.
4.
Return the print ribbon cartridge to the printer.
5.
Close the printer cover. Press down on the ridges on the front of the cover to make sure that
it latches properly on both sides.
6.
Have rewritable cards available to insert into the printer.
When you print rewritable cards, insert the cards one at a time. Make sure that the
card is engaged in the pick rollers. The erase/rewrite process can cause the cards to
bend slightly, and can prevent them from being picked from the input hopper.
To print rewritable cards, you also must do the following:
Enable rewritable printing in Printer Manager.
Refer to the Printer Setting Print section in the printer's Installation and Administrator's
Guide for information about specifying Printer Manager settings for rewritable cards.
Specify rewritable card settings in the Card Printer Driver.
For complete information about setting up the Card Printer Driver to print rewritable cards,
refer to your printer's Driver Guide.
22 Using the System