How To Set The Data Source(S) - Furuno FI-70 Operator's Manual

4.8

How to Set the Data Source(s)

The FI-70 automatically detects and connects to data sources within the network.
These settings can be changed as required by doing the following:
1. Access the [System] menu using the procedure outlined on page 4-1.
2. Press the software keys to select [Data Source], then press the function key.
3. Press the software keys to select the appropriate source, then press the function
key.
Source
[Position]
[Heading]
[STW]
[SOG]
[Navigation]
[Depth]
[Water Temp.]
[Wind]
[AIS]
[Tank1] thru [Tank6]
4. Press the software keys to select the appropriate sensor, then press the function
key.
5. Repeat the procedure to adjust other sensor's settings as necessary.
6. Press the Menu/Back key twice to close the menu.
Automatic data source switching
The FI-70 can automatically switch data sources if data from the set source is
interrupted or lost, provided there is a suitable sensor connected to the same network
as the FI-70.
AIS and all tank sensors are not switched automatically.
Data Source
Position:
SC-30
Heading: SC-30
STW:
SOG:
Ent
Data source for position related information (GPS, etc.)
Data source for heading related information
Data source for Speed Through Water
Data source for Speed Over Ground
Data source for navigation
Data source for depth
Data source for water temperature
Data source for wind angle/speed
Data source for AIS related information
Data source for tank related information
:000200
:000200
----------------
----------------
----------------
Description
4. SYSTEM MENU
4-11