Xerox ApeosPort-III C7600 User Manual page 141

1
Remove any paper clips and staples before
loading the document.
2
Adjust the movable document guides to
match the size of the document loaded.
Note • When loading a large document such as
3
Place the document (the front side of 2-sided
document) face up in the center of the
document feeder.
Note • The indicator lights up when the
• When documents are loaded into the
Document Glass
The document glass supports a single sheet, a book, or other similar documents from
15 x 15 mm up to 297 x 432 mm (A3, 11 x 17").
Important • After using the document glass, close the document cover.
The document glass automatically detects standard size documents.
Note • The standard document sizes that can be detected automatically depend on the [Paper Size
CAUTION
Do not apply excessive force to hold thick document on the document glass. It may
break the glass and cause injuries.
1
Open the document cover.
Important • Ensure that a screen is displayed on the
A3, open the document stopper
rightward.
document is loaded correctly.
document feeder, the document feeder
tray lifts up. The timing of the lift can be
programmed in [System Settings]. For
more information, refer to "5 Tools" >
"Common Service Settings" > "Other
Settings" > "Document Feeder Tray Elevation" in the Administrator Guide.
Settings] in the System Administration mode. For information on the paper size settings,
refer to "5 Tools" > "Common Service Settings" > "Other Settings" > "Paper Size Settings" in
the Administrator Guide
control panel, and then load a document.
If a document is loaded before a screen is
displayed, the machine may not properly
detect the document size.
Fax Procedure
Indicator
139
4