Xerox ApeosPort-III C7600 User Manual page 124

3 Copy
Hole Punch
Sets the position for punching. Finisher C/Finisher C w/Booklet offers three different
punch positions to choose from: 2 Holes, 2 Holes Top, 2 Holes Right.
D-Finisher with Booklet Maker offers six different punch positions to choose from: 2
Holes, 2 Holes Top, 2 Holes Right, 4 Holes, 4 Holes Top, 4 Holes Right.
Important • Confirm that the orientation of the document and the [Original Orientation] setting of the
Original Orientation
Allows you to specify the orientation of the document to have the machine identify the
top of the document.
Note
Upright Images
Select this item when placing the top edge of the document against the top side of
the document glass or document feeder.
Sideways Images
3
Select this item when placing the top edge of the document against the left side of
the document glass or document feeder.
Z Fold Half Sheet
The machine folds the output copies in Z fold. Z fold can be applied to B4, A3, 11 x 17".
If you have mixed sized documents, the width (vertical direction) of the paper must be
the same, such as a combination of A4 (portrait) and A3 (landscape), and a
combination of B5 (portrait) and B4 (landscape). For example, if you have a
combination of A4 (portrait) and A3 (landscape), the Z fold is only applied to A3.
Output Destination/Offset
Allows you to select the output destination tray and offset operation.
Offset Stacking
This is displayed if you select [Right Middle Tray] for the output destination.
The offset is a function for slightly offsetting and outputting each paper stack to allow
you to distinguish the separations. You can specify by set, job, specified number of
pages, or specified number of copies for a paper stack.
122
[Layout Adjustment] screen are the same.
• If the [Original Orientation] differs from the actual document orientation, then the machine
may mistakenly detect the top of the document.