Toshiba T4400SXC Maintenance Manual page 106

Assembling the LED Board
To assemble the LED board in the top cover follow these steps:
4-22
1. Place the LED board in the LED holder as shown in figure 4-17 and snap the
latches securing it in place.
2. Place the LED holder in the top cover as shown in figure 4-16, leaving the
display cable connections slightly elevated so you can connect the three
display cables and display power-off switch cable to the LED board.
3. Place the LED holder in place as shown in figure 4-15 and secure it with the
two screws (M2x4 and M2.5x4) removed in step 4.
4. Place the plastic cover over the bottom of the top cover as shown in figure 4-14
and secure the support bridge with the single screw (M2x5 silver) removed in
step 3.